Channel-plus MDS-6 User Manual download pdf (Page 7)

AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR.

WARNING: SHOCK HAZARD - DO NOT OPEN.

IR REMOTE OUTPUTS

SOURCE OUTPUT

SUM OUTPUT

INFRARED (IR) SECTION

16.) Source Output #1 through 4 - This 1/8 2 conductor jack is for the IR emitters and are locked

source specific. This is useful in for instance, if you have 2 or more of the same brand CD player,

since the same IR command will work on both, this ONLY sends the IR command to this particular

source. Nearly any brand of emitter will work. There are four source specific IR jacks.

This connector is duplicated for the remaining 3 outputs and function exactly the same as the first

one.

17.) Sum Output #1 through 4 - This 1/8 2 conductor jack is for the IR emitters and are summed

across the IR buss. This will allow normal operation of different components that dont share the same

IR commands. There are four sum output IR jacks.

This connector is duplicated for the remaining 3 outputs and function exactly the same as the first

one..

18.) AC Power - This is where the AC power cord connects to the unit. It is a detachable 3 prong

I.E.C. plug. Never remove the ground lug on the plug or electrical shock and damage to the unit could

result.

INSTALLATION NOTES

# Use Category 5 8-conductor cable. It is not necessary for it to be shielded but be careful with

your cable runs. Avoid running a tight parallel with AC wiring. Be careful if stapling the wire to secure

it in place.

# Use high quality RJ-45 connectors and make sure you use a high quality crimp tool. The crimp

of the RJ-45 connectors is crucial in making the system work properly.

# Avoid tight or sharp turns near the ends of the RJ-45 connections to the controller or main

units. This can put excessive strain on already small wires.

# Note when stacking multiple units: Audio sources connect via the distribution outputs. Wall

controllers combine via the Master Controller Out jack. Make a short jumper and connect to the second

units Master Controller In jack to allow the party mode master controller to access all zones. For

the IR Emitters, we strongly suggest using a Y adapter for the emitters that attach directly from the

sources and then to the second units IR outputs. This allows the source specific functionality to be

utilized by the second MDS-6. An additional controller can be run per zone by using a RJ-45 Y

adapter before the main unit.

Page 4

WIRING DIAGRAM FOR REMOTE ROOM CONTROLLERS

TO MCS-1 or MCS-2

DATA LINE C

DATA LINE B

DATA LINE A

+5 VOLT D.C.

GROUND

IR SIGNAL

CLONE

STANDBY

TO MDS-6

RJ-45

PLUG

RJ-45

PLUG

CLIP

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Comments to this Manuals

No comments

Channel-plus MDS-6 User Manual Page 7

Comments to this Manuals