Channel-plus MDS-6 User Manual download pdf (Page 18)

Page 10

1) Remove the Decora cover plate, and controller face plate.

2) Place your wireless remote in learn mode.

3) Select the device bank button to program (i.e. TV, VCR, Tuner, Aux, etc.) on the wireless remote.

4) Select the button to be programmed on the learning remote. (i.e. 1-6, mute, or volume up and down)

5) While holding the wireless remote within 2" from the top, center, clear LED on the MCS-1 (this is the

controller IR emitter), press the command button on the MCS-1 Controller you wish to program into the

wireless remote.

6) The wireless remote should then accept the MCS-1 command.

7) Once you have programmed the source number, volume up and down, and mute functions. You

can then go to the memory bank on your wireless remote chosen for the MDS-6 system to change

volume, source, or mute the system from any zone in the house.

*Please Note:

When programming, it is best to hold the MCS-1 or MCS-2 button until the wireless remote has indicated

that it has learned the command.

PROGRAMMING A WIRELESS REMOTE

USING THE MCS-1 OR MCS-2 WALL CONTROLLER

1 2 ... 13 14 15 16 17 18 19 20 21 22

No comments

Channel-plus MDS-6 User Manual Page 18